** Insert line number on each extracted line. ** Extract the same sequence multiple times. ** Using regular expressions when to start and stop extracting. ** Extract using several different search criteria. ** Where to place the extracted lines in the tool list file. * Extracting lines from the NC file and inserting them in the tool list, Added new Tool list generator with support for the following new features:.Normally the order of the operation will be optimised but sometimes the order of operations are more important than the optimisation and in these cases "Machine as Selected" will ensure that the operations are performed in the order they were selected. Machine as selected is only in play when multiple contour pockets etc.Staydown Distance is the maximum distance a transition move is made in the XY plane before it is replaced with a retract and reposition move. * Staydown Distance: Works as it have always done in Contour, but now it is added to Pocket and Constant Cut as well. * Plunge relative to last depth: Moving down to make a new cut should we always make the transition from rapid to feed safe distance above the part or should this transition point be relative to the last cut depth. * Use Rapid Retract: Controls if the retract should be in rapid move from the bottom or if we should move to safe distance in feed and then switch to rapid. These new parameters make it possible to optimise the operations with the following parameters: * Retract Type: Controls if every retract should be to the retract height or just to the safe distance over the part. New linking page inserted in Pocket, Contour and Constant cut parameters.The colors defined in the Global Colors setup is now used when displaying measurements and nc toolpaths in CNC-Calc.
0 kommentar(er)
